smaller flaker

Description

Shell: The shell and the protective cover plate on both sides are painted with carbon steel plate, and the front and rear upper and lower door plates are painted with aluminum plate.
☆ Movable door panel: Movable door panel and sampling port are equipped with rubber seal, and easy to open or disassemble; There is a sampling port or door below the body, which is used to check the effect of rolling embryo for adjustment.
☆ Body: The whole machine adopts fully closed structure, with heat dissipation net on both sides, square bearing seat, with wear-resistant self-lubricating plate, wear replacable, up and down slideway, live roll parting roll moving back and forth, make the roll run more smoothly, increase the service life. The front hydraulic device with dial adjusting locking device can adjust the thickness of billet online under working condition without pressure relief.
☆ Motor: single machine drive mode, the motor is universal asynchronous motor, motor working voltage is AC 380V; Frequency 50HZ, with oil injection port.
☆ Bearing: The main engine bearing at both ends of the roll is provided with an oil filling device (one bearing oil filling port for each bearing), and the oil filling port is located outside the belt cover and connected by the pipe.
☆ Roll: The roll adopts German centrifuge casting high nickel chromium molybdenum alloy roll, uniform hard layer, increase the service life, hardness is HS75±3, roll casting roll surface thickness 30-40mm, China a heavy German centrifuge casting roll blank, roll into action balance test.
☆ Standard parts with synchronous belt wheel.
☆ Scraper: The scraper blade plate is smooth and in good contact with the roll surface, the blade plate can be disassembled and adjusted, the counterweight scraper to adjust the limit scraper, the scraper plate can be adjusted in vitro after long-term use and wear.

Technical Data

Send us a message

Related Products